Taylor Racing Components from Team UC Irvine Formula SAE 2002
 |
This is our general set-up for the 2002 Formula car. What you can purchase from Taylor Racing are the tripod bearings, the races, the cv guards, the boots, and the half-shaft.(the taylor set-up is completely assembled at the bottom of the picture) [zip ties not included] |
| Here's a closer look at the tripod bearing and race. The circlip is also purchased seperately. You must machine the circlip groove and cut the halfshaft to length(as mentioned in the Taylor-Race flyer for FSAE) |
 |
 |
The white piece seen here is made from Delrin and stops the tripod from plunging too deeply. |
| Here the stopper is pulled out and reveals a spring that allows the stopper to plunge a little. The rest of the cv was machined and the stub axle, that has the splined end to pick up the hub, is welded to it. |
 |
 |
This is a picture of the other CV/stub axle piece. This part connects to the race and is an output from the diferential. |
|
More info can be found here: http://www.taylor-race.com/subcat1.cfm?category=Drive%20Axle%20Components They have a link to a very useful flyer. |
|
equalizing washer |
|